Arpicade software installation - "input not detected"

Thinking about getting a RaspberryJAMMA, or have just purchased one and have a newbie question? Walls here are padded, come on in and bounce your question off of them!

Moderator: dee2eR

Post Reply
vinny_bellmore
Observer
Observer
Posts: 1
Joined: Sun Aug 22, 2021 9:15 pm

Arpicade software installation - "input not detected"

Post by vinny_bellmore » Sun Aug 22, 2021 9:22 pm

Hi,

I think I followed the download/install directions, but when I turn my arcade on I get the error message "input not detected". However, when I switch SD cards to retropie, it boots. I know retropie is not compatible with arpicade, it was just to confirm the software is not properly installed on the arpicade SD card.Image SD card images attached.

Help!
Attachments
arpicade2.PNG
arpicade2.PNG (72.84 KiB) Viewed 2293 times
arpicade1.PNG
arpicade1.PNG (73.05 KiB) Viewed 2293 times

dee2eR
Inventor
Inventor
Posts: 1857
Joined: Tue Aug 22, 2017 2:07 pm

Re: Arpicade software installation - "input not detected"

Post by dee2eR » Mon Aug 23, 2021 1:59 am

Default ARpiCADE settings are for low res. Sounds like you have a high res monitor or RetroPie wouldn't have worked. Did you set ARpiCADE to high res in config.txt?

The input not detected message is from your monitor.

Post Reply