High resolution mode vga - beginner question
Posted: Thu Sep 09, 2021 2:55 pm
Hello! Last night was the first night I got my arpicade with a pi 4 8gb, up and running, everything seemed to work- however I am having issues setting up the config file to allow for high res.
My monitor is reporting a "signal not supported" message
My monitor is a hannspree lcd, and according to the documentation, the device supports 640x480@60 but in the documentation (I have attached a screenshot) "60" is actually, 31.469 vertical x 59.941 horizontal.
So my question(s) are as follows; and thanks for entertaining some day 1, "new guy" questions
What are the correct settings to enable 640x480 in the config file? Hdmi group? And hdmi mode values? Do these very specific horizontal and vertical refresh timings need to be called out somewhere in the config file?
Also, how do I tell the pi to switch over to the high res versions of these roms?
Again thank you for any help!
My monitor is reporting a "signal not supported" message
My monitor is a hannspree lcd, and according to the documentation, the device supports 640x480@60 but in the documentation (I have attached a screenshot) "60" is actually, 31.469 vertical x 59.941 horizontal.
- 2021-09-08 23_25_20-Pc Mode Support Timing - HANNspree Xv HT09 User Manual [Page 36] _ ManualsLib.png (41.59 KiB) Viewed 2643 times
What are the correct settings to enable 640x480 in the config file? Hdmi group? And hdmi mode values? Do these very specific horizontal and vertical refresh timings need to be called out somewhere in the config file?
Also, how do I tell the pi to switch over to the high res versions of these roms?
Again thank you for any help!