Hello, recently installed an Arpicade into a spare arcade cabinet I have for running Mame exclusively. It's all working EXCEPT when I press button 2 "P1B1" during a game the game will reset.
I have gone through all the input options that I could find and don't see anything mapped to that button except P1B1.
I am running 3.9 on a B3+ pi. I tried 3.7 but 3.7 would consistently boot to the low power lightning bolt so I tried 3.9 and that's been fine except this one issue.
I have not changed any button mapping, I even re-imaged the SD card to make sure I didn't screw it up somehow.
2 questions.
1. is 3.9 the recommended release for my setup?
2. If not any ideas as to what I can do / reconfigure to make the games quit resetting when pressing button P1B1?
Thanks in advance.
EDIT: I can coin up with P1 start + P1B0. I can get into the settings menu for each game with P1 start + P1 right.
Game resetting P1B1
Moderator: dee2eR
Re: Game resetting P1B1
Not sure what would be going wrong there.
It's probably worth trying ARpiCADE 3.X as that is the latest version, I don't remember encountering this problem in 3.9 though so it may not help...
Does it happen in all MAME versions or a specific one only?
It's probably worth trying ARpiCADE 3.X as that is the latest version, I don't remember encountering this problem in 3.9 though so it may not help...
Does it happen in all MAME versions or a specific one only?
-
- Community Member
- Posts: 2
- Joined: Tue Jun 08, 2021 3:03 am
Re: Game resetting P1B1
I have not tried 3.X yet. I will try it tomorrow.
I tried 2 versions of mame and both did it.
Thanks.