Hello,
I installed the 3.X version on my SD-card on my RPI3 model B+ and get 4 slow red flashed followed by 4 fast red flashes. Also ran into this issue with v3.7.
Now I downloaded the official RPI OS to rule out an issue with my PI and this seems to be working fine.
Does anyone run into the same issue or do I need the newest version of the Arpicade software?
RPI 3B+ boot issues
Moderator: dee2eR
Re: RPI 3B+ boot issues
I used Etcher by the way on a 32GB uSD card.
Re: RPI 3B+ boot issues
Not sure whats going wrong for you there. 3.X the right (and current, excepting it's add-on 3.X.1 update) version for your board, 3.7 wouldn't work as it pre-dates the 3B+.
It's worth retrying 3.X, may have just been bad luck with the imaging the first time (no idea why).
It's worth retrying 3.X, may have just been bad luck with the imaging the first time (no idea why).
Re: RPI 3B+ boot issues
Well, you're right. I reimaged the correct version 3.X but I imaged it to the wrong drive. Had a memory stick next to my uSD card and flashed the memory stick. The uSD card was still holding the 3.7 version which of course didn't function in the PI3.
Thanks for your support.
Thanks for your support.
Re: RPI 3B+ boot issues
Glad you're up and running.
I hope you didn't have anything important on the memory stick.
I hope you didn't have anything important on the memory stick.