Is there a spec or install guide for the 4-player board? I've searched but couldn't find anything that identifies the the pinouts for the harness connectors, DIP switch settings or functions of the buttons on the board. (other than the ones obviously labeled)
I'm using it in a Konami 4-player cab, but the CP was converted to 2-player so I don't have the stock harness to reference.
- Dave
Spec for 4-player board
Moderator: dee2eR
Re: Spec for 4-player board
https://drive.google.com/file/d/1Bd1Lav ... sp=sharing Konami wiring is on the last page.
- FrizzleFried
- Legendary Contributor
- Posts: 328
- Joined: Sat Nov 25, 2017 5:35 pm
- Location: Idaho
- Contact:
Re: Spec for 4-player board
...this is probably a stupid question, but...
I have an NBA Jam... that is inside a Konami style cabinet....
One would assume that it's been converted to NBA Jam connectors, no?
I have an NBA Jam... that is inside a Konami style cabinet....
One would assume that it's been converted to NBA Jam connectors, no?
Visit my arcade blog ... www.idahogaragecade.com (Updated: 10/28/21)
Re: Spec for 4-player board
If it had an original NBA Jam board in it I imagine the player 3 and 4 wiring would have been adjusted to match.
- FrizzleFried
- Legendary Contributor
- Posts: 328
- Joined: Sat Nov 25, 2017 5:35 pm
- Location: Idaho
- Contact:
Re: Spec for 4-player board
Do you have a 4-P module doc with NBA Jam pinouts (the one linked above is only Konami)...
Thanks!
Thanks!
Visit my arcade blog ... www.idahogaragecade.com (Updated: 10/28/21)
Re: Spec for 4-player board
it's just standard NBAJam pinout, there's no extra buttons on the NBAJam "m" headers.