Hi,
I think I followed the download/install directions, but when I turn my arcade on I get the error message "input not detected". However, when I switch SD cards to retropie, it boots. I know retropie is not compatible with arpicade, it was just to confirm the software is not properly installed on the arpicade SD card. SD card images attached.
Help!
Arpicade software installation - "input not detected"
Moderator: dee2eR
-
- Observer
- Posts: 1
- Joined: Sun Aug 22, 2021 9:15 pm
Arpicade software installation - "input not detected"
- Attachments
-
- arpicade2.PNG (72.84 KiB) Viewed 2352 times
-
- arpicade1.PNG (73.05 KiB) Viewed 2352 times
Re: Arpicade software installation - "input not detected"
Default ARpiCADE settings are for low res. Sounds like you have a high res monitor or RetroPie wouldn't have worked. Did you set ARpiCADE to high res in config.txt?
The input not detected message is from your monitor.
The input not detected message is from your monitor.